How To Change Transmission Fluid In A 2008 Ford Escape
How to Modify Transmission Fluid on a Ford Escape
past Allen Moore
Justin Sullivan/Getty Images News/Getty Images
Ford Motor Company recommends servicing the transmission in your Ford Escape every xxx,000 miles or less. If yous employ your Escape to tow ofttimes, make frequent short trips, or drive primarily in finish and go traffic, you may desire to adjust that interval downwards as far as 20,000 miles, depending on how often yous appoint in the aforementioned driving activities. While information technology is best to have the transmission professionally flushed, in the event that is only not possible, draining the fluid from the pan and replacing it is your best bet.
Footstep i
Put on your safety glasses. Engage the parking brake and place the wheel chocks in the front end and dorsum of the rear tires.
Step 2
Jack the front end of the Escape up carefully. Place jack stands nether the subframe, one on each side. Lower the Escape gently onto the jack stands. Pull the jack out of the mode.
Stride 3
Put the drain pan underneath the transmission pan. Then employ the socket ready to loosen all the transmission pan bolts virtually 1/8-inch.
Step 4
Use the screwdriver to carefully pry the rear of the transmission pan away from the transmission, if the pan did non drop when the bolts were loosened. Use extreme care not to distort the pan or gouge the manual sealing surface.
Pace five
Slowly remove the pan bolts at the rear of the pan, allowing the transmission fluid to pour over the rear edge of the transmission pan and into the bleed pan.
Footstep six
Remove the residuum of the pan bolts. Pour the last of the fluid out of the manual pan into the drain pan.
Footstep vii
Lift the old transmission pan gasket off the pan and discard information technology. If it sticks to the pan, you made demand to carefully scrape information technology off with a razor blade.
Pace eight
Clean the transmission pan past spraying it downwards with brake clean and then wiping it off with rags. Brand certain the sealing surface is make clean.
Step ix
Seat the new manual pan gasket onto the pan.
Step ten
Reinstall the pan and bolt information technology dorsum in place. It is easiest to hold the pan upward and partially thread in a commodities in each corner to hold it upwardly. Then, you can put in the rest of the bolts and tighten them down.
Step 11
Refer to your Escape's specific owner's manual for transmission fluid capacity and cascade that amount into the transmission dipstick tube. Information technology is best to put a funnel at the superlative of the dipstick and pour the fluid into the funnel.
Pace 12
Outset the Escape with your foot firmly on the restriction. Shift information technology through the gears and dorsum into park. Check your transmission fluid level on the dipstick and add accordingly if needed. It is best non to add together more than ½-quart at a time before rechecking the level.
Shut the engine off and check for leaks around the pan. When washed, jack the front end finish support, remove the jack stands and advisedly lower the Escape back onto the ground.
References
Things You'll Need
- Safety glasses
- 4 wheel chocks
- Jack
- Jack stands
- Drain pan
- Socket set
- Flathead screwdriver
- Brake clean and rags
- Razor bract (optional)
- Transmission pan gasket
- Funnel
- Mercon V manual fluid
Writer Bio
Allen Moore's career includes awards in poetry and creative fiction, published lyrics, fiction books and nonfiction articles as well every bit a master certification in automotive service from the Ford Motor Company. Moore is a contributing writer for RF365.com and various other websites, a ghostwriter for Rainbow Writing and has over a dozen works of fiction currently in impress.
More than Articles
Source: https://itstillruns.com/change-transmission-fluid-ford-escape-6178916.html
Posted by: truesdalehimat1991.blogspot.com
0 Response to "How To Change Transmission Fluid In A 2008 Ford Escape"
Post a Comment